LED profile LINEA-IN20 EE7F/U7 4050 white painted

 
The LINEA-IN20 aluminium inlet LED profile by the Polish company TOPMET is ideally suited for installation in suspended ceilings or plasterboard. The profile dimensions allow to use of LED strips up to 20 mm. When using an LED strip with appropriately selected power and an opal cover, the LINEA-IN20 LED profile can be the main lighting in the room without visible LED points.

A wide selection of connectors for the LINEA-IN20 LED profile allows you to create geometric lines of light and various types of transitions at the ceiling-wall interface (using connectors specified in our store as the BENT connector). With this profile, you are limited only by your imagination in obtaining a binding with an interesting design.

Various covers are available. The most preferred and convenient cover for mounting is the F cover. An interesting solution is the E7 cover, which protrudes over the profile by 1.5 cm and the light spreads from three sides to its entire surface acting as an interesting, efficient fixture. If you are installing a small section of the LED LINEA-IN20 profile in an easily accessible place, you can choose the E slide cover.

It is recommended to install the LINEA-IN20 LED profile using a dedicated U7 spring mounting plate (cone U7 mounting plate, which will allow veneering the profile with the mounting surface or with a delicate U7 spacer; U7 spring mounting plate for solid assembly and easy disassembly of the profile in the plasterboard.

DEDICATED COVERS:

• E slide cover (transparent, frosted, opal)
• F click cover (transparent, opal, black)
• E7 cover (opal) - it is necessary to buy an E7 endings
  
  

DEDICATED MOUNTING PLATES:

• U7 mounting plate
  
• cone U7 mounting plate
• spring U7 mounting plate

DEDICATED CONNECTORS:

• LINEA-IN20 60deg
  
• LINEA-IN20 90deg
  
• LINEA-IN20 60deg
  
• LINEA-IN20 90deg bent
  
• LINEA-IN20 120deg
  
• LINEA-IN20 135deg
  
• LINEA-IN20 180deg
  
• LINEA-IN20 270deg bent
  

JOINING POSSIBILITIES: